Roland GAIA 2 - Parameter list (SH-101)

114
Navi
Parameter list (SH-101)
TONE Parameters
TONE TONE
SH-101SH-101
* You may not be able to obtain the controller eect that you want with tones that use MFX Control.
Parameter Value Explanation
OSCOSC
OSC LFO MOD
0–100 Adjusts the depth at which the LFO modulates the OSC.
OSC RANGE
16’, 8’, 4’, 2’ Species the oscillator’s octave.
PULSE WIDTH
MOD
0–127
PW MODE =MANUAL Adjusts the pulse width value.
PW MODE =LFO/ENV Adjusts the depth of modulation.
PW MODE
Species the pulse width mode.
LFO The pulse width is aected by the LFO.
MANUAL The pulse width is aected by PULSE WIDTH MOD.
ENV The pulse width is aected by ENV.
COMMONCOMMON
Tempo
20.00–300.00 Sets the tempo of the tone (including the arpeggio, motion and sequencer).
BEND PITCH
0–1500 Species the range of pitch change produced by pitch bend.
BEND FILTER
-63–0–+63 Species the range of lter change produced by pitch bend.
MODULATION
LFO
-63–0–+63 Species the amount of LFO applied by modulation.
PORTA MODE
Turns portamento on/o. If this is on, the pitch will change smoothly from one note to the next-played
note.
OFF Regardless of the portamento time setting, portamento is not applied.
ON Portamento is always applied.
AUTO
Portamento is applied only when you play legato (pressing the next key before
completely releasing the previously-played key). This lets you use your playing
technique to control portamento on/o.
PORTA TIME
0–1023 Adjusts the time over which the portamento pitch change occurs.
PORTA CRV
Species the pitch change curve for portamento.
ORIGINAL Change according to the original curve of the model.
LINEAR Change on a linear curve.
EXP1 Change in a non-linear curve (gentle slope).
EXP2 Change in a non-linear curve (steep slope).
KEY MODE
Species how notes are sounded.
POLY Polyphonic
SOLO Monophonic
UNISON Unison
SL-UNISON Monophonic unison
AFT LFO
-63–+63
Sets how much aftertouch changes the LFO intensity.
* This is only enabled for products with aftertouch.
AFT FREQ
-63–+63
Sets how much aftertouch changes the low-pass lter intensity.
* This is only enabled for keyboards with aftertouch.
AFT LEVEL
-63–+63
Sets how much aftertouch changes the tone volume.
* This is only enabled for keyboards with aftertouch.