Roland GAIA 2 - Page 49

49
Navi
TONE parameters
TONE TONE
GAIA-2GAIA-2
Parameter Value Explanation
OSC1OSC1
Range
64’, 32’, 16’, 8’, 4’, 2’ Adjusts the octave of the oscillator.
Pitch
-1200–0–+1200
(cent)
Adjusts the pitch of the oscillator.
* The pitch may not reach the value that you set, depending on the sound parameter
settings.
Wavetable
Position
0–127 Adjusts the wavetable position.
S-Mod Table
Number
1–15
Selects the shaping modulation table.
P-Mod Limiter
Sw
OFF, ON When set to “ON”, this limits the depth of the phase modulation X direction.
Wave
1–63 Selects the wavetable.
P-Mod X
-63–0–+63 Adjusts the depth of the phase modulation X direction.
P-Mod Y
-63–0–+63 Adjusts the depth of the phase modulation Y direction.
S-Mod Depth
0–127 Adjusts the intensity of the shaping depth for shaping modulation.
S-Mod Drive
0–127 Adjusts how much drive is applied to the shaping modulation.
OSC2 / OSC3OSC2 / OSC3
Range
64’, 32’, 16’, 8’, 4’, 2’ Adjusts the octave of the oscillator.
Pitch
-1200–0–+1200
(cent)
Adjusts the pitch of the oscillator.
* The pitch may not reach the value that you set, depending on the sound parameter
settings.
Waveform
Selects the oscillator waveform.
SIN Sine wave
TRI Triangle wave
SAW Sawtooth wave
PULSE Pulse wave
SUPER-SAW Super-Saw
NOISE Noise
Sine Shape
Select
PW, FAT
Sets what happens when you operate a sine wave shape.
PW: Alters the waveform width.
FAT: Emphasizes the lower frequencies.
Triangle Shape
Select
PW, FAT
Sets what happens when you operate a triangle wave shape.
PW: Alters the waveform width.
FAT: Emphasizes the lower frequencies.