Roland JD-XA - Test Mode

24
Jul. 2015 JD-XA
Test Mode
Items Required
• Computer (running Windows 7)
• USB memory device (recommended: M-UF2G)
•USB cable
•MIDI cable
• Foot switch (DP-2, etc.)
• Expression pedal (EV-5) x 2
* Adjust the minimum volume knob to 0.
• Oscilloscope
•Noise meter
•Tester
•R-05
* 14. MIC IN (XLR) (p. 29) and 16. MIC IN (TRS) (p. 29) can also be tested with
an oscillator and a DI-1.
• Amp-equipped monitor speaker
• Headphones
• Dummy plug
•USB driver
Obtain this from the following web pages, and install it on the computer
just described.
http://www.roland.co.jp/
http://www.roland.com/
• KY004_MIC.WAV
Obtain via Service Net, and copy it to the SD card in the R-05 just
described.
• KY004_USB.WAV
Obtain via Service Net, and copy it on the computer just described.
Entering the Test Mode
Hold down 01, 03 and 05 and switch on the power.
* Continue to hold down the three buttons above until the version is displayed on
the screen.
Quitting the Test Mode
Switch off the power.
Skipping Test Items
Shift + : This forces execution to advance to the next test item.
Shift + : This forces execution to return to the previous test item.
Shift + Menu: The test item select screen appears.
Use or to select the test item, then press Enter to jump to the
item.
* Some test items cannot be accomplished correctly unless testing is performed in
sequence.
* If pressing Shift + Menu in some test items, you can not return to the test item
select screen.
Test Items
1. Version (p. 24)
2. Device (p. 26)
3. USB Over Current (p. 26)
4. MIDI (p. 26)
5. ROTARY SW (p. 26)
6. Switch/LED (p. 26)
7. Switch (p. 26)
8. LED (p. 27)
9. LCD (p. 27)
10. A/D (p. 27)
11. Phones Out (p. 27)
12. Main Out (L/MONO, R) (p. 28)
13. CLICK OUT (p. 28)
14. MIC IN (XLR) (p. 29)
15. MIC DC (p. 29)
16. MIC IN (TRS) (p. 29)
17. USB FUNC (p. 30)
18. Wave ROM (p. 30)
19. MUTE (p. 30)
20. Keyboard (p. 30)
21. Factory Reset (p. 30)
22. ErP Check (p. 30)
23. Residual Noise Check (p. 31)
24. Pop Noise Check (p. 31)
25. Aftertouch Check (p. 31)
Test items of 23–25 are carried out in the normal mode.
1. Version
This verifies the version of the program.
+————————————————+
|Appli:1.01(00**)|
|yy/mm/dd **:** |
+————————————————+
The version of the program is displayed on the screen.
1. After verifying the version, press +.
The boot version is displayed.
+————————————————+
|Boot :1.00(00**)|
|yy/mm/dd **:** |
+————————————————+
Verify the boot version.