6. LFO • LFO Modulation Knob
When the Cutoff Point of the VCF is being modulated by the output CV of the LFO, this knob adjusts the depth of the
grow! or wah effect.
7. KYBD • Key Follow Knob
When the Cutoff Point is being controlled by the KYBD-CV {Keyboard control voltage), this knob adjusts the level of
the KYBD-CV. It prevents any inconsistency in the harmonic content caused by pitch alteration. Consequently this
knob is usually set to the maximum on such a long keyboard, but can be set to your taste.
NOTE
The self-oscillation of the VCF does not guarantee an accurate pitch. Therefore, you cannot expect a correct scale
when playing the keyboard.
If using the VCF self-oscillation as a sound source, its pitch may turn out unstable, since the Cutoff frequency does
not change continuously. In such a case, change the position of the FREQ Knob (2) until you get a stable pitch. (If
you write it into memory once and recall it, the pitch will be stable.)
To Next Page
Loading...
