Roland juno-ds61 - Using the JUNO-DS with DAW Software; JUNO-DS as Audio Interface; Saving DAW Control Settings

38
Using the JUNO-DS with DAW Software
Using the JUNO-DS As an Audio Interface
The JUNO-DS’s audio output you’ve specied can be recorded into DAW software
on your computer.
Sound from your computer can also be reproduced from a device that’s connected
to the JUNO-DS’s OUTPUT jacks.
1.
Connect the JUNO-DS to your computer.
2.
Start up your DAW software, and choose “JUNO-DS” as the audio input
device and output device.
For details on how to make this setting, refer to the owner’s manual of your DAW
software.
Saving the DAW CONTROL Settings
The DAW CONTROL settings revert to their previous state when you turn o the
power. If you want the DAW CONTROL settings to be remembered even after power-
o, save them.
1.
In the DAW CONTROL screen (expect in the “Part Edit” tab), press the [WRITE]
button.
* If you press the [WRITE] button when the “Part Edit” tab is selected,
PERFORMANCE WRITE is executed.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
2.
Move the cursor to “OK,” and press the [ENTER] button.
Saving is complete when the screen indicates “Completed!”
NOTE
Never turn o the power while the screen indicates “Writing....”
MEMO
When you save the DAW CONTROL settings, the system settings are also saved.