45
Editing Using Only the JV-1010
Quick Start
5
Turn the VALUE knob to change the level. This can be set in
the range 000–127.
Pan, Coarse Tune, and other parameters can be set in the same way. For
more detailed information about each parameter and its settings, refer to the
Reference Manual that is on the included CD-ROM.
6
While holding down the VOLUME knob, press the VALUE
knob.
The JV-1010 exits Edit mode.
Memory-Related Operations (UTILITY)
These operations include initialization of data such as the JV-1010 internal
sound data, and transmission of settings to external devices.
fig.1-31
■ Restoring the Factory Settings (Factory Reset)
This operation restores all settings stored in the JV-1010 to their condition at
the time the unit was shipped from the factory.
For more detailed information and instructions for this procedure, refer to
the “Reset to Default Factory Settings (Factory Reset)” (p. 21).
Turning off the JV-1010’s
power without saving the
created data results in the
loss of that data. Save any
important data that you
wish to preserve to an
external MIDI device (p.
48).
To Next Page
Loading...
Need help?
General
