21
Quick Start
Reset to Default Factory Settings (Factory Reset)
When using the JV-1010 for the first time, start by returning the settings to
their factory defaults so that the JV-1010 operates as described in the
procedures in the owner’s manual.
This returns all settings stored in memory in the JV-1010 to the values they
had when the unit was shipped from the factory.
fig.1-09
1
Press the VALUE knob to switch to a mode other than the
Patch mode (PATCH), that is, to the PERFORM, RHYTHM, or
GM mode.
2
While holding down the VOLUME knob, press the VALUE knob.
Switch to the Edit mode.
3
Turn the CATEGORY/BANK knob to choose PIANO (Factory
Reset).
Fct flashes on the display.
In the Edit mode, choosing PIANO (Factory Reset) with the CATEGORY/
BANK knob makes it possible to perform Factory Reset.
4
Press the VALUE knob.
Sur flashes on the display, prompting you to confirm that you indeed wish
to carry out a Factory Reset.
fig.Sur
5
Press the VALUE knob.
The Factory Reset is performed, and you leave the Edit mode.
1,4,52 3
If there is important data
you’ve created that’s stored
in memory, all such data is
discarded, and everything is
returned to the factory
defaults when a Factory Reset
is performed. If important
data is stored in the unit, save
it on an external MIDI device
(p. 48).
When in the Patch mode, you
can’t enter the Edit mode.
For more information
about the CATEGORY/
BANK knob’s other
functions in Edit mode,
refer to the EDIT
PARAMETER SELECT
chart on the JV-1010’s top
panel.
To exit from the Edit mode
without carrying out a
Factory Reset, follow the
same procedure as in step 2.
To Next Page
Loading...
Need help?
General
