46
Editing Using Only the JV-1010
■ Initializing GM Mode (GM Initialize)
Using a computer or sequencer connected to the JV-1010 to play music data
bearing the GM logo requires the system be initialized for GM. Carrying out
this initialization restores the basic GM settings.
fig.1-32
1
Press the VALUE knob to switch to the GM mode (GM).
Pressing the VALUE knob makes the mode change sequentially. Press the
knob several times, until the GM indicator lights up.
2
While holding down the VOLUME knob, press the VALUE
knob.
Switch to the Edit mode.
3
Turn the CATEGORY/BANK knob to choose KEY&ORGAN
(GM Initialize).
Gin flashes on the display.
4
Press the VALUE knob.
Sur flashes in the display; this is a prompt for you to confirm whether or not
you want to execute GM Initialize.
fig.Sur(GM)
5
Press the VALUE knob.
GM Initialize is executed, and the JV-1010 exits Edit mode.
32 1,4,5
The GM Initialize operation
affects only GM mode data;
no data stored in the user
memory is initialized. If
you want to restore all
settings to their factory
values, carry out Factory
Reset (p. 21).
When in the Patch mode,
you can’t enter the Edit
mode.
To exit Edit mode without
executing GM Initialize,
carry out the operation
described in Step 2.
To Next Page
Loading...
Need help?
General
