WARNING
Do not share an outlet with an unreasonable
number of other devices
Otherwise, you risk overheating or re.
Do not use overseas
Before using the unit in overseas, consult
with your retailer, the nearest Roland
Service Center, or an authorized Roland
distributor, as listed on the “Information.”
Handle lithium batteries carefully
• Lithium batteries must never be
recharged, heated, taken apart, or
thrown into a re or water.
• Keep lithium batteries out of reach
of small children. If a child has
accidentally swallowed a battery, see a
doctor immediately.
• Never expose lithium batteries to
excessive heat such as sunshine, re
or the like.
Turn the unit o before installing interface module
Before installing the interface module,
you must rst always turn o the unit and
unplug its power cord.
CAUTION
Place in a well ventilated location
The unit should be located so that its
location or position does not interfere
with its proper ventilation.
When disconnecting the power cord, grasp it by the
plug
To prevent conductor damage, always
grasp the power cord by its plug when
disconnecting it from this unit or from a
power outlet.
Periodically clean the power plug
An accumulation of dust or foreign
objects between the power plug and the
power outlet can lead to re or electric
shock.
At regular intervals, be sure to pull out the
power plug, and using a dry cloth, wipe away any dust
or foreign objects that may have accumulated.
Disconnect the power plug whenever the unit will
not be used for an extended period of time
Fire may result in the unlikely event that a
breakdown occurs.
Route all power cords and cables in such a way as
to prevent them from getting entangled
Injury could result if someone were to
trip on a cable and cause the unit to fall
or topple.
Avoid climbing on top of the unit, or placing heavy
objects on it
Otherwise, you risk injury as the result of
the unit toppling over or dropping down.
Never connect/disconnect a power plug if your
hands are wet
Otherwise, you could receive an electric
shock.
Cautions when moving this unit
Since this product is very heavy, you must
make sure that a sucient number of
people are on hand to help, so you can lift
and move it safely, without causing strain.
Make sure to have a rm grip, to protect
yourself from injury and the instrument from damage.
If you need to move the instrument, take note of the
precautions listed below.
• Disconnect the power cord.
• Disconnect all cords coming from external devices.
Before cleaning the unit, disconnect the power
plug from the outlet
If the power plug is not removed from the
outlet, you risk receiving an electric shock.
Whenever there is a threat of lightning, disconnect
the power plug from the outlet
If the power plug is not removed from the
outlet, you risk receiving an electric shock.
CAUTION
Handle lithium batteries carefully
• Use only the specied type (model no.
CR2032) of lithium batteries (p. 22). Be
sure to insert it as directed (to ensure
correct polarity).
• Used lithium batteries must be
disposed of in compliance with
whatever regulations for their safe
disposal that may be observed in the
region in which you live.
Install only specied interface module
Install only the specied interface module.
Remove only the specied screws (p. 24).
Keep small items out of the reach of children
To prevent accidental ingestion of the
parts listed below, always keep them out
of the reach of small children.
• Included Parts
Ferrite core (p. 15)
REAC connector cover (p. 16)
• Removable Parts
REAC cap (p. 16)
Screws
Handle the ground terminal carefully
If you remove the screw from the ground
terminal, be sure to replace it; don’t leave
it lying around where it could accidently
be swallowed by small children. When
refastening the screw, make that it is
rmly fastened, so it won’t come loose.
Precautions concerning use of phantom power supply
Always turn the phantom power o
when connecting any device other than
condenser microphones that require
phantom power. You risk causing damage
if you mistakenly supply phantom power
to dynamic microphones, audio playback devices, or
other devices that don’t require such power. Be sure to
check the specications of any microphone you intend
to use by referring to the manual that came with it.
(This instrument’s phantom power: DC+48 V, 14 mA Max)
USING THE UNIT SAFELY
5
To Next Page
Loading...
Need help?
General
