Roland M-5000 - Setting the Date and Time; Factory Reset; Fader Calibration

Overview of Operations
61
Setting the Date and Time
1. At the HOME screen, tap <DATE & TIME AREA>.
The DATE & TIME window appears.
2. Set the date and time, then tap <SET>.
The settings for the date and time are applied.
Factory Reset
This initializes the M-5000, returning it to its factory-default state.
NOTE
Performing initialization causes all data to be lost.
Data that is needed can be saved to a USB ash drive.
0“Backing Up All Data in the M-5000” (p. 59)
0“Restoring All Data in the M-5000” (p. 60)
1. Go to the Display section on the top panel, and while
holding down the [MENU] button and [VIEW] button, turn
on the power to the M-5000.
2. Tap <FACTORY INITIALIZE>.
A popup prompting you to conrm the initialization operation is
displayed.
3. Tap <INITIALIZE>.
Initialization starts.
NOTE
Never turn o the power to the M-5000 before initialization
nishes.
4. When “Factory Initialize completed.” appears, turn o the
power.
Fader Calibration
If the fader positions are no longer aligned with the index markings
of the top panel, carry out fader calibration to adjust.
1. Press the [MENU] button.
2. AT the MENU window, tap <SYSTEM>, then tap <FADER
CALIBRATION>.
The FADER CALIBRATION window appears.
3. Tap an item from <-INF> to <+10dB>.
This moves to the location where all faders are supported.
4. Adjust the fader that is not aligned with the index
markings on the top panel.
The <UPDATE> appears.
5. Tap <UPDATE>.
The fader position is adjusted to the specied location.