Cutting (One Side Cutting)
106
Adjusting the Feed Rate and Spindle Speed During Cutting
The feeding speed and number of rotations of a spindle can be adjusted during cutting by VPanel.
Adjusting Cutting Speed (Override)
This works for the speed of cutting tool movement
when cutting the workpiece. The speed specied by
the command in the cutting data is taken to be 100%.
Adjusting Rotation Speed of the Spindle
This works for the rotation speed of the spindle. Move
the slider to set the speed between “Low” and “High.”
* The speed cannot be specied from any application
other than VPanel.
To Next Page
Loading...
Need help?
General
