Roland monoFab SRM-20 User Manual

144
Massage is Displayed
Message Responding Page
No modeling machine was found.
If the power is o, then switch it on.
If the cable is unconnected, then connect it.
Check connection of a USB cable.
After you take actions such as turning on the power and
connecting the cable, press [Retry].
"“Start VPanel” (p. 11)
"“VPanel Does Not Recognize
the Machine” (p. 126)
The modeling machine is not responding.
Make sure that the connection cable is connected securely and the
machine is switched on.
Check connection of a USB cable.
After you take actions such as turning on the power and
connecting the cable, press [Retry].
" “Operations Are Ignored”
(p. 127)
The SRM-20 has performed an emergency stop.
- X-Limit switch not found.
- Y-Limit switch not found.
- Z-Limit switch not found.
- The NVRAM could not be accessed.
Switch the machine
’s power o, then back on again.
If the symptom persists, a malfunction may have occurred.
Switch o the machine's power and contact your authorized
Roland DG Corporation dealer where you purchase the
machine.
The SRM-20 is paused.
- Cover opened during operation.
Operation cannot be continued.
In order to resume cutting, please close a front cover and
click [RESUME].
Click [STOP], when you stop cutting.
"“Pausing / Resuming” (p. 104)
"“Cancel the Cutting” (p. 105)
The SRM-20 is paused.
- Command Error
You can ignore this and continue with cutting, but doing
so is very likely to result in unintended operation, so we
strongly recommend you stop cutting.
If command does not match the machine's command set,
select correct command set.
"“STEP 3 : Conrm the Command
Set” (p. 83)
"“Cancel the Cutting” (p. 105)
Responding to Error Messages

Roland monoFab SRM-20 Specifications

General

Brand	Roland
Model	monoFab SRM-20
Category	Power Tool
Language	English