Roland MP200 - Overall Operation and Display Settings; Auto Power Off Configuration

27
Making Various Settings (Function Mode)
Indication Value Explanation
Reg. Pedal
Shift
You can assign a pedal to successively switch registrations (p. 11). Each time you press the pedal, you will switch to the next
registration.
* Pedal function settings take priority in the following order: “Reg. Pedal Shift”
0
“Center/Left Pedal.”
O Pressing the pedal does not change the registration.
Left Pedal
The soft pedal can be used only for switching registrations. In this case, the function assigned to the soft pedal
cannot be used.
Center Pedal
The sostenuto pedal can be used only for switching registrations. In this case, the function assigned to the
sostenuto pedal cannot be used.
MIDI-related settings
Local Control
Preventing Doubled Notes When Connected to a Sequencer (Local Control)
When you have a MIDI sequencer connected via USB, set this parameter to Local O.
Since most sequencers have their Thru function turned on, notes you play on the keyboard may be sounded in duplicate, or
get dropped. To prevent this, you can enable the “Local O” setting so that the keyboard and internal sound generator will be
disconnected.
O
Local Control is o.
The keyboard is disconnected from the internal sound generator. Playing the keyboard will not produce sound.
On
Local Control is on.
The keyboard is connected to the internal sound generator.
MIDI
Transmit Ch.
MIDI Transmit Channel Settings (MIDI Transmit Ch.)
This setting species the MIDI channel on which the unit will transmit.
This unit will receive all sixteen channels (1–16).
O, 1–16
Overall operation settings
Language
Changing the Language Displayed in the Screen (Language)
You can change the language that is displayed in the screen.
English, Japanese, Chinese
Display
Contrast
Adjusting the Brightness of the Display (Display Contrast)
You can adjust the brightness of the piano’s display.
1–10
Screen Saver
Specifying the Time Until the Operating Panel Is Dimmed (Screen Saver)
When no operation has been performed for a specied length of time, the display will go blank and the operating panel button
LEDs will go dark. The display reappears when you perform an operation.
You can specify the time until the panel goes dark.
O, 30 sec., 1 min., 5 min., 10 min.
Volume Limit
Specifying a Maximum Volume (Volume Limit)
You can specify a maximum volume value. This lets you prevent loud sound from being produced unintentionally.
MEMO
You can also set the volume limit by holding down the [ ] knob and turning the [ ] knob.
20, 40, 60, 80,100
Auto O
Making the Power Automatically Turn o After a Time (Auto O)
With the factory settings, the unit’s power will automatically be switched o 30 minutes after you stop playing or operating the
unit. If you don’t want the power to turn o automatically, change the “Auto O” setting to “O” as follows.
O, 10, 30, 240 (min)