6
° Before You Play
Opening the Keyboard Cover
1. Open the keyboard cover.
To open the keyboard cover, use both hands to lift it lightly, and
slide it away from yourself.
* When opening or closing the keyboard cover or operating the
pedals, take care not to pinch your ngers between the moving
part and the body of the unit. Pay special attention to this when
using the unit where children are present.
Using the keyboard cover to conceal the panel
(Classic Position)
If you pull the keyboard cover slowly from the full open position, it
stops at a position that hides the buttons and the display. If you use
the cover to hide the operation panel, you’ll be able to play as though
you were playing an acoustic piano. When you push the cover further
inward and up, it stops in a position where the operation panel is
visible.
Keyboard cover
NOTE
Take care that foreign objects, such as sheet music or other
papers, do not enter the piano through openings in the keyboard
cover. Also, do not open the cover while papers are placed on the
cover. Doing so might make the papers impossible to remove,
causing malfunctions.
Using the Music Holders
You can use the holders to hold pages in place. When not using the
holders, leave them folded down.
Turning the Power On/O
Turning the power on
1. Press the [
L
] (power) button.
After a few seconds, you can play the keyboard to
produce sound.
* To protect the circuitry, there is a brief interval after
the power is turned on before the piano starts operating.
* If external speakers are connected to the piano, minimize the
volume of your external devices before turning on this unit.
Turning the Power O
1. Long-press the [
L
] (power) button.
The power turns o.
* Never disconnect the power cord 10 seconds after turning the
power o. Malfunctions might occur if you disconnect the power
cord while the system is still processing.
* You might hear some sound when switching the unit on/o.
However, this is normal and does not indicate a malfunction.
Concerning the Auto O function
The power to this unit will be turned o automatically after a
predetermined amount of time has passed since it was last used
for playing music, or its buttons or controls were operated (Auto
O function).
If you do not want the power to be turned o automatically,
disengage the Auto O function (p. 27).
* Any settings that you are in the process of editing will be lost
when the power is turned o. If you have any settings that you
want to keep, you should save them beforehand (p. 29).
* To restore power, turn the power on again.
Adjusting the Overall Volume
Turn the [ ] knob to adjust the volume.
The speaker volume and headphone volume can be set separately.
Turn the [ ] knob
Turning the knob toward the right increases
the volume, and turning the knob to the left
decreases the volume.
Press the [
] knob The screen shows the current volume setting.
To Next Page
Loading...
Need help?
General
