©FEEL
FUNCTION
3.
How
to
Store Feel Patch
Settings
Here's
how
to store a modified Feel Patch (temporary area) into the
memoiy area.
* If you wish to store the data
on a RAM card, remember that a newly purchased
RAM card,
or a RAM card that has been used
for other devices, cannot be used as it is.
You must first
use the Save operation to save internal data
to the RAM card. For details refer
to "Using a
RAM Card"
(
cr
page
60).
[ABOUT MEMORY
PROTECT!
The memory protect function is a protective
measure to prevent you from accidentally rewriting
the
Patch or Feel Patch settings in the internal memory
area. If you
wish
to store Patch
or Feel Patch
settings in the internal memoiy area,
you
must
first turn this memory protect off. When storing
data on
a RAM card, you must turn
the card protect switch off.
Normally you will temporarily turn memory protect
off during the write procedure. However,
if you
will be repeating the write procedure
many
times,
you can turn memory protect
off beforehand to
avoid this
extra step. To tum memory protect off
beforehand, refer to page 56.
I
Feel Patch write
procedure
Here's how to write Feel Patch (temporary
area) settings into
either of the memoiy areas.
Temporary area
Write
Memory area ]
Internal RAM card
Feel Patch
Feet Patch 1:
Feel Patch
C-01
ji
1-01 ::
..J
*To store data on
a
RAM
card, turn the protect switch
off
after inserting
the RAM card.
(D
Move to the Feel Patch write
display.
Press
!
EDlT] (the indicator will light).
Use the
CURSOR
RIfFI
to select
"FEEL" and press
]
ENTER
|
.
Use the
CURSORlT][F|to select "WRT" and
press
|
ENTER
|
.
Use the
CURSOR
HE
to select "WRITE"
and press
IENTERX
FEEL.--
WRT.-- WRITE
TMP
>
F!
1-01?
T
Feel
Patch number
®
Use the
CURSOR [^[]to
select
the destination Feel Patch number into which
you wish to
write.
I-Ol—
1-16
(internal Feel Patches),
C-01—C-I6 (RAM card Feel Patches)
Press
I
ENTER
and
you
will
be asked "Are you sure?".
®
Press
I
ENTER
|
once
again and the data will
be
written.
To quit without
writing
press
| EXIT |.
51
To Next Page
Loading...
Need help?
General
