2323
Other functions
Selecting an Imported Tone
1. In the Scene screen, use the cursor buttons to select
the zone whose tone you want to change.
Move the cursor to the tone name.
2. Press the [ENTER] button.
The tone list appears.
3. Press the [ENTER] button to display the Bank
screen.
Each time you press the [ENTER] button, you alternate between
the Category screen which sorts tones by category and the Bank
screen which sorts tones by bank.
4. Use the cursor [ç] [æ] buttons to select the USER
bank.
The list of imported tones appears.
5. Use the cursor [ä] [å] buttons to select a tone.
MEMO
¹ After selecting a tone, press the [EXIT] button to return to the
Scene screen.
¹ If you want to save the settings, execute the Scene write
operation.
“Saving a scene (write)” (p. 20)
Returning to the factory settings
(FACTORY RESET)
Here’s how the settings that you edited and saved on the RD-08 can be
returned to their factory-set condition.
* When you execute this operation, all the settings that you modied
after purchasing the RD-08, including the sound parameters, are
lost.
* If you will later need the current settings, be sure to use the backup
function (p. 21) to save the current settings before you restore
the factory settings.
1. Press the [MENU] button.
2. Use the cursor [ä] [å] buttons to select “UTILITY”,
and then press the [ENTER] button.
3. Use the cursor [ä] [å] buttons to select “FACTORY
RESET”, and then press the [ENTER] button.
If sound packs
are imported or installed
The item selection screen appears.
4. Use the cursor [ä] [å] buttons to select the item
that you want to execute, and then press the
[ENTER] button to add a check mark in the check
box.
Pressing the [ENTER] button once again clears the check mark.
Item Explanation
Reset User
Data
Settings and data other than user licenses and
wave expansions are initialized.
* When you execute this operation, all settings that you
edited after purchase, including sound parameters, will
be erased.
* If you want to save the current settings, be sure to
use the backup function (p. 21) to save the current
settings before you reset the unit to the factory settings.
Remove
License
Initializes the user license.
Initializing the user license lets you import/install a
sound pack that was downloaded with a dierent
user license.
* When you execute this operation, the installed wave
expansions are deleted.
* This operation does not delete the EXZ001.
* For more about user licenses, refer to “Sound Pack Installation
Manual” (PDF).
5. Press the cursor [æ] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
6. To execute, use the cursor [æ] button to select “OK”,
and then press the [ENTER] button.