Roland RD-500 - Effect and Detune Pitch Settings

2. Press the CONTROL button as many times as necessary until the display responds with :
Bender Switch Modulation Switch Damper Switch
| | Mm mM
b nm d 110 d d J IP
3. Select the Part you wish to edit using the LOWER/UPPER buttons.
4. Select ON or OFF using the INC/DEC buttons or VALUE slider.
“Pressing any Numerical Key while setting the Pedal (in “Setting the PedalCi1_
Slider on page 27) or the Damper Switch (in the above step 2) will invert the
polarity of the pedal connected to the INT+TX/TX PEDAL or the DAMPER PEDAL
jack. When the polarity is reversed, a point appears in the display.
* When the CONTROL button in the INTERNAL SOUNDS Section is lit in Function
mode, pressing the pedal connected to the INT+TX or the TX PEDAL jack will call
the pedal setting display. Moving the bender lever will call the Bender/Modulation
Switch display while pressing the pedal switch connected to the DAMPER PEDAL
jack will call the Damper Switch display.
@ Effect Settings
When Chorus and Reverb are on, you can set the effect parameters for Chorus and Reverb or for
Tremolo and Vibrato in each Tone Group.
* If you select a different Tone in the same Tone Group, the edited effect settings will be erased.
VALUE |. EQUALIZER Laver? °° gpur®
Be 5 ; GRAND.) GRANG 2. E.GRAND » MKS-20
: 2. FA Pa GCG
log : LEVEL HODEB E.RIAND HARDS ORGAN
STRINGS BASS CUS!
AUNT.“ TRANSPOSE | DEC inc REVERB LOWER. UPPER s'
1. Select the Function mode.
2. To edit the Effect setting of the Tone assigned to the LOWER Part, press the LOWER button.
To edit the Tone assigned to the UPPER Part, press the UPPER button.
3. Select the parameter to be edited.
Two parameters are assigned to each of the DEPTH, TIME and TREMOLO buttons (as shown later on
this page). These parameters will be selected alternately by pressing the button. The parameter
currently selected is shown in the display.
4. Change the values using the INC/DEC buttons, VALUE slider or Numerical Keys.
29