Roland RD-500 - Controlling Part Volume; Setting Key Zones for Parts

@ Controlling the Volume
TKOAT LEVEE TO
TOWER “UPPER ;
TX CONTROL
@ INT LOWER/INT UPPER Parts
Turn off the TX/INT button (the indicator will go out) and adjust the volume using the TX/INT LEVEL
sliders.
* The value set using the procedure described on page 20 will be the maximum volume of each
Part. It is not possible to obtain any higher volume.
@ TX LOWER/TX UPPER Parts
Turn on the TX/INT button (the indicator will light) and adjust the volume using the TX/INT LEVEL
sliders.
@ Setting the Key Zone
You can set the Key Zone to which each of the INT LOWER/INT UPPER/TX LOWER/TX UPPER Parts
is assigned.
Does not sound Key Range Does not sound
(Sound)
* The Key Zone setting is effective in the Split mode.
@ Setting the Key Zone of the INT LOWER/INT UPPER Parts
IZER LAYER: SPUT GRAND 1 GARAND 2 E.GRANO MKS-2z0
f DETUNE PITCH RK ZONE KEV TOUCH INDICATOR == LOTAL
a
t CHORUS TION: RHODES. E.PIANO HANS, ORGAN
DEPTH * SOR!” TRANG : TREMOLO SENSITIVITY BENO DOWN BEND UP
: FUNC - TRANSPOSE EC” ‘REVERB LOWER UPPER STRINGS BASS PERCUSSION |
™.
Se ; NAL SOUNDS
@"'®
2. Press the ZONE button in the INTERNAL SOUNDS section (the indicator will light).
1. Select the Function mode.
3. Press the LOWER or UPPER button to select the Part to be edited.
49