Roland RD-500 - Page 50

Pe
a
a
a
4. Specify the Zone (section) to which you wish to assign the Part.
While holding down the lowest key in the Zone, press the highest key in the Zone.
The Key Name of the pressed key will appear in the display.
Key Range
Hold down Press the highest key
* If you press only one key, it will be the highest note of the INT LOWER section and the lowest
note of the INT UPPER Part (section). (Like a Split Point setting.)
When the LOWER button Is flashing : When the UPPER button is flashing :
Key Range of LOWER part Key Range of UPPER part
@ Setting the Key Zone of the TX LOWER/TX UPPER Parts
1. Select the Function mode.
2. Press the ZONE button in the TX CONTROL section (the indicator will light).
3. Press the LOWER or UPPER button to select the Part to be edited.
4. Set the Key Zone to which the Part should be assigned.
Use the same procedure as with the INT LOWER/INT UPPER Parts.
Key Range
Hold down Press the highest key
50