Roland RD-600 - Selecting Sounds (Tones)

Selecting a sound (Tone)
The RD-600 contains a total of 128 different tones (preset sounds).
These Tones are selected by specifying the group (A/B), category (PLANO 1-CLAV/MALLET)
and variation (1-8).
Rhythm Sets are assigned to B86-B88. Ordinary Tones will produce the same sound no matter
which note is played, but a Rhythm Set will sound a different percussion instrument for each
key.
For the built-in Tones and Rhythm Sets, and for the percussion sounds that are assigned to each
key of a Rhythm Set, refer to the included Tone List and Rhythm Set List (back cover).
® ®
PART SELECT
LOWER {MG URPER LOWER —-BE:8~— UPPER
CS os
INTERNAL TONE CATEGORY
PIANO 1 PIANO 2 E.PIANO ORGAN STRINGS PAD BASS/LEAD CLAV/MALLET
INTERNAL TONE VARIATION
1.Press one of the PART SELECT buttons for the INT part to specify the part (Upper or Lower)
for which you wish to select a Tone, making the indicator light.
If you select the INT UPPER part, the indicators of the Part Select button and the
Group / Category / Variation buttons will light red. If you select the INT LOWER part, the indi-
cators of the Part Select button and the Group/ Category / Variation buttons will light green.
2. Press a Group button to select the group of the Tone.
3. Press a Category button to select the category of the Tone.
4. Press a Variation button to select the variation of the Tone.
5. Make sure that the selected Tone appears in the display.
*
For some Tones, the keyboard range in which the Tone will sound may be limited, or the pitch may not
change when you exceed a given keyboard range.
The selected Tone cannot be played unless the Part switch indicator of the Part for which the Tone was
selected ts lit.
For some of the BASS/LEAD Tones, no more than one note can sound simultaneously.
Making it easier to select a Tone (Tone Memorize function)
If you once again press the Variation button for the selected Tone, the following display will
appear, and the selected variation will be memorized. When you next select the same Category,
the Tone of the memorized variation number will be selected without your having to press a
Variation button.
* This function can be used only when an INT part is selected.
* This setting will be remembered even if you turn the power off.
13