Roland RD-600 - Reverb Parameters; Reverb Type Selection; Adjusting Reverb Level and Time

3. Use the [INC/ YES] [DEC/NO] buttons to modify the valuc of the setting.
* By holding down the [INC/YES] ([DEC/NO]) button. and pressing the [DEC/NO] (LINC/YES}) but-
fon you can increase (decrease) the value more rapidly.
4. Repeat steps 2~3 as necessary.
5.When you are finished, press the [EDIT] button to make the indicator go dark. You will return
to normal playing condition.
Reverb parameters .
Reverb settings include the following parameters.
Reverb Type
Reverb Level
Reverb Time
Reverb HF Dump
Delay Feedback
Type (Reverb Type)
You can choose from the following eight types of reverb.
ROOM1, ROOM2: These reverbs simulate the reverberance of a room. They provide a well-
defined and spacious reverberance.
STAGE1, STAGE2: These reverbs simulate the reverberance of a stage. They provide a rever-
berance with strong presence.
HALL, HALL2: These reverbs simulate the reverberance of a hall. They provide a deep reverberance.
DELAY: This is a conventional delay. It produces an echo effect.
PAN-DELAY: This is a special delay in which the delayed sounds jump between left and right.
It is effective when stereo connections are used.
E
Fewerk
Tope
a STAGE?
Depth (Reverb Level)
This sets the depth of the reverb. The reverb will become deeper as the setting is increased.
EReverk Level + Range of values: 0-127
2H
Reverb Time
This sets the length of time that the reverb will continue. The reverb time will become longer as
the setting is increased.
ERewerk Tire
Range of values: 0-127
kt BG
35