Roland RD-600 - EFX Selection and Depth; Selecting EFX Type; Setting EFX Level (Depth); Reverb;Chorus Settings Procedure

eBoeR
aae
cR
ART
R
gRSINTT
I
TSTTI
E
TEIIO
I
I
D
BIT
EES
I
ERE
ASLO
SIEM
MEET,
Bend Range
For Tones assigned to a TX part, setting the maximum value will assign that value to both the
upper and lower limits. You can simultaneously press the [INC/YES] [DEC/NO] buttons to
turn this setting OFF, so that Pitch Bend message will no longer be transmitted from MIDI OUT.
TRend Rana Range of values: OFF, 0- +24
Te LL Ail :
Selecting the type of EFX (EFX)
This setting specifies the effect that will be applied.
For details on the different EFX types, refer to p.56.
TE.Ordern 1 a
EF
Yb
Rober
* EFX effects cannot be applied to Tones of the TX parts.
* If the EFX type is set to BYPASS, there will be no effect.
Setting the depth of the EFX effect (EFX Level)
For some types of EFX, turning the EFX on will cause the volume to increase. This setting
allows you to set the level of the effect so that the volume balance will be maintained even
when the EFX is turned off.
TE.Crgan 1
Range of values: 0-127
EFM Level
* If this parameter is set to 0, there will be no sound.
Reverb/Chorus settings
Reverb is an effect which adds reverberance and ambiance to the sound, creating a feeling of
space. It simulates the impression that is produced when you play in a concert hall.
Chorus broadens the spatial image of the sound, adding depth and luster.
For each of the effects you can specify parameters such as Type, Depth and Rate.
Procedure
aL) (5)
“at PAGE »
BEC/NO INC/YES
1. Press the [EDIT] button to make the indicator light, and you will enter Edit mode.
2.Use the PAGE [ ~ ][ > ] buttons to select the parameter that you wish to modify.
Select a parameter prefixed by a “E” character. The setting value is displayed below the para-
meter name.
* By holding down the PAGE [ » ] ([ « ]) button and pressing the PAGE [ «] ([ = ]) button you can
move rapidly in the [ = ] ({ « ]) direction.
Parameter
Setting group | ERewerh Lewel
34