Roland RD-600 - Setting the Operating Environment

TVitlale Mint-Me) S-actilit: MN ee tal
System settings
Here you can set parameters which affect the entire RD-600. These parameters are referred to as
System parameters.
Procedure
eoIT
<@ PAGE »
DEC/NO- INC/YES
1. Press the [EDIT] button to make the indicator light, and you will enter Edit mode.
2. Press the PAGE [ « ][ > ] buttons to select the parameter that you wish to modify.
Select a parameter prefixed by a “S” character. The setting value is displayed below the para-
meter name.
* By holding down the PAGE [ = ] ({ « ]) button and pressing the PAGE [<] ({ = ]) button you can
move rapidly in the | = ] (| « ]) direction.
Parameter
Setting group f7,_-;—. _
Amita Easter Ture
F446, BH=
3. Press the [INC/YES]/[DEC/ NO] buttons to modify the setting.
* By holding down the [INC/YES] ([DEC/NO]) button and pressing the [DEC/NO] ({INC/YES]) but-
fon, you can increase (decrease) the setting rapidly.
4. Repeat steps 2~3 as necessary.
5. When you are finished, press the [EDIT] button to make the indicator go dark. You will return
to normal playing mode.
System parameters
System settings include the following parameters.
Master Tune
Key Touch
FC Assign (FC1)
FC Polarity (FC1)
FC Assign (FC2)
FC Polarity (FC2)
DamperPolarity
Control Ch.
Device ID
MIDI Thru/Out2
Powerup Mode
LCD Contrast
49