Roland RD-600 - System Tuning and Keyboard Touch; Master Tune for Pitch Matching; Adjusting Keyboard Touch Sensitivity; Foot Controller Function Assignments

TUS TT EEE ENE TTL TE ETS TEE EY LIES OI ETT IT LT NE IE I IT TO a NI SOE I ET OTE EES EELS EE EL EE ETE,
Setting the pitch to match other instruments
(Master Tune) ......cssssccssescscecccssccsscseeecccccesseseeeeDefault value: 440.0 Hz
When you are playing in an ensemble with other instruments, or need to set the RD-600 to
match the pitch of another instrument, adjust the Master Tune. The displayed value is the fre-
quency of A4 (middle A).
SMaster Tune Range of values: 427.4-452.6 (Hz)
e440, GHz
Adjusting the key weight (Key Touch)..............Default value: MEDIUM
The RD-600 allows you to adjust the touch of the keyboard. This is a feature found only on digi-
tal pianos, that would not be possible on an acoustic piano.
LIGHT: Fortissimo (ff) can be produced by a lighter touch than usual, creating the impression
that the keyboard is lighter.
MEDIUM: This is the normal setting, and allows you to play with the most natural touch.
HEAVY: Fortissimo will not be produced unless you play more strongly than usual, creating
the impression that the keyboard is heavier. By playing dynamically, you will be able to put
more emotion into your music.
Skew Touch
FAECIUM
Foot controller 1 function setting (FC1 Assign).....Default value: Sosten
Foot controller 2 function setting (FC2 Assign).........Default value: Soft
An expression pedal or pedal switch connected to the rear panel FC1 and FC2 jacks can be used
to control the internal sound source or an external MIDI sound source.
The following functions can be assigned to a pedal. (CC indicates the controller number.)
CC1: Mod Modulation
CC7: Volume Volume
CC10: Pan Panpot
CC11: Expres Expression
CC64: Hold 1 Hold
CC66: Sosten Sostenuto
CC67: Soft Soft
50
CC91: RevSend
CC93: ChoSend
Reverb amount
Chorus amount
EFX: Rate/Sns EFX rate/sensitivity
EFX: Dept/Lvl EFX depth/level
EFX: Level EFX level
at
Uo lume
* If in the local part settings, the Transmit Ch. of a TX part is set to INT (p.40), EFX: Rate/Sens, EFX:
Dept/Lol and EFX: Level messages will also be transmitted from MIDI OUT.