Roland RD-600 - Pedal Polarity and MIDI Memory Selection; Pedal Polarity Settings; Selecting Setup Memories via MIDI; Device ID Number Settings

Foot controller 1 polarity setting (FC1 Polarity)
Foot controller 2 polarity setting (FC2 Polarity) Default value: STANDARD
This setting lets the RD-600 match the polarity of the expression pedal or pedal switch that is
connected to the rear panel FC1 or FC2 pedal jack. If you are using a Roland pedal switch (such
as the DP-2), set this to STANDARD.
If you are using a pedal switch with opposite polarity made by another manufacturer, set this
to REVERSE.
SFC Polarits Range of values: STANDARD, REVERSE
FCI FS TAHDARD
Damper pedal polarity setting (DamperPolarity)......Default value: STANDARD
This setting lets the RD-600 match the polarity of the pedal switch that is connected to the rear
panel damper pedal jack. If you are using a Roland pedal switch (such as the DP-2), set this to
STANDARD.
If you are using a pedal switch with opposite polarity made by another manufacturer (ie., if
the damper effect is applied even though you are not pressing the pedal), set this to REVERSE.
SDanrerPolaritue Range of values: STANDARD, REVERSE
& SO TAHHOARE
Using MIDI program changes to select setup memories
(Control Ch.) walbiceudeeeucccdkasvadecdoudsaxaenasescroibaksianiadiaasess DOTAUIT value: OFF
You can specify a channel that will be used for selecting setup memories. If this channel coin-
cides with the receive channel of an internal part, program change messages received on that
channel will select setup memories instead of selecting Tones. If this parameter is turned OFF,
incoming program change messages will not select setup memories.
* The receive channel for each part is specified by the internal part parameters (p.45).
SCornteol Ch,
_ Range of values: OFF, 1-16
FOFF
Setup memories correspond to program number as follows.
Si1 1 $12 2 S13 3 S14 4 S15 5 S16 6 S17 7 S18 8
S21 9 $22 10 S23 11 $24 12 $25 13 S26 14 $27 15 S28 16
$31 17 $32 18 S33 19 S34 20 S35 21 S36 22 S37 23 S38 24
$41 25 S42 26 S43 27 S44 28 S45 29 S46 30) S47 31 $48 32
$51 33 $52 34 $53 35 S54 36 S55 37 S56 38 S57 39 S58 40
S61 41 S62 42 S63 43 S64 44 S65 45 S66 46 S67 47 S68 48
$71 49 S72 50 S73 51 $74 52 $75 53 S76 54 $77 55 S78 56
S81 57 S82 58 S83 59 S84 60 S85 61 S86 62 S87 63 S88 64
Device ID number settings (Device ID)..............002+.+...-Default value: 17
The device ID number is an identification number that is used when transmitting and receiving
exclusive messages. The RD-600 is able to receive exclusive data that carries the same device ID
number as its own setting. When using exclusive messages to transfer data, the device ID num-
bers of both devices must be set to match.
thevice If Range of values: 17-32
#1 PC 1GHS
51