Roland RD-600 - Sound Adjustments: Equalizer, Reverb, Chorus; Equalizer Settings; Reverb Effect; Chorus Effect

When you play a C on the keyboard, a pitch of E will now be sounded.
Adjusting the level of the low/mid/high frequency ranges — Equalizer —
The RD-600 contains a 3-band equalizer.
After pressing the EQUALIZER [ON/OFF] button to turn on the indicator, use the LOW / MID
/ HIGH knobs to adjust the low, mid, and high frequency ranges of the sound.
Rotate the konbs to make adjustments
* When the EQUALIZER [ON/OFF] button indicator is dark, the equalizer settings will have no effect.
* The equalizer affects only the output of the OUTPUT jacks. It does not affect the output of the FIXED
OUTPUT jacks.
Adding reverberation to the sound — Reverb effect —
Press the [REVERB] button to turn on the indicator, and a reverb effect will be added to the
sound.
* The depth of the reverb can be adjusted independently for each Tone. If this setting is 0, there will be
no effect even if reverb is turned on (p.33). In this case, the indicator will blink.
* For details on reverb settings, refer to p.34.
Adding spaciousness or modulation to the sound — Chorus effect —
Press the [CHORUS] button to make the indicator light, and a chorus effect will be added to the
sound.
* The depth of the chorus can be adjusted independently for each Tone. If this setting is 0, there will be
no effect even if chorus is turned on (p.33). In this case, the indicator will blink.
* For details on chorus settings, refer to p.34.
19