Roland RD-600 - Applying EFX (Multi-Effects)

Applying other effects — EFX —
EFX is a multi-effector which provides 40 types of effect.
Some of these 40 types consist of a single effect unit, and others consist of several effect units in
combination. EFX can be set for each Tone, and when the RD-600 was shipped from the factory,
appropriate EFX settings were made for each Tone. You can take advantage of the EFX settings
for each Tone in the following ways.
A. Using the Tone settings of the INT UPPER part to apply an effect to the Tone of
the INT UPPER part
@ Press the EFX [UPPER] button to make the indicator light. The indicator will light red.
OEPTH/
LEVEL
RATE/
SENS
B. Using the Tone settings of the INT LOWER part to apply an effect to the Tone of
the INT LOWER part
@ Press the EFX [LOWER] button to make the indicator light. The indicator will light green.
RATE? DEPTH?
SENS. LEVEL
oO O
C. Using the Tone settings of the INT UPPER part to apply an effect to the Tones of
both the INT UPPER and LOWER parts
@ Hold down the EFX [UPPER] button and press the EFX [LOWER] to make both indicators light.
Both indicators will light red.
REVERB
Hold down
D. Using the Tone settings of the INT LOWER part to apply an effect to the Tones of
both the INT UPPER and LOWER parts
@ Hold down the EFX [LOWER] button and press the EFX [UPPER] button to make both indica-
tors light. Both indicators will light green.
REVERS
Press
RATES OEPTH/
SENS LEVEL
Hold down
When you select EFX, you will be able to use the RATE/SENS and DEPTH/LEVEL knobs to
adjust the parameters of that effect, so that rotating the knobs will directly change the way in
which the effect is applied. For the parameters assigned to the RATE/SENS and
DEPTH/LEVEL knobs, refer to p.56.