Roland RD-600 - Page 21

REVERB
=
CHORUS
Se
* The type and level of EFX can be specified independently for each Tone. If the EFX type is set to
BYPASS or the EFX Level is set to 0, the EFX button indicator will blink (p.34).
* The settings that you make with the EFX knobs are remembered independently for each Tone.
* For some types of EFX, a slight amount of noise may be heard when you move the RATE/SENS and
DEPTH/LEVEL knobs, but this is not a malfunction.
Let's try using EFX
Here we will apply a ROTARY effect to the E.Organ 8 (A48) Tone. (ROTARY is an effect which
simulates the sound of a rotating speaker.)
PART SELECT
LOWER C=) p= UPPER LOWER C= UPPER
50:
INTERNAL TONE ee eer
GROUP
A rSETUP. B
PIANO 1 PIANO 2 E.PIANO ORGAN STRINGS BASS/LEAD T=)
INTERNAL 1 ONE oT
ad eo ee
1. Double-click the INT UPPER part select button to make the indicator light. The indicator of the
INT UPPER part switch will also light. (The indicators of the other part switches will be dark.)
2. Press GROUP [A] / CATEGORY [ORGAN] / VARIATION [8] to make the corresponding indi-
cators light. Make sure that the upper line of the display is as shown in the figure.
ASS°5E,0rdan &
Bar tHe ser
E.Organ 8 has now been assigned to the INT UPPER part.
3. Press the EFX [UPPER] button to make the indicator light.
The RATE/SENS knob is assigned as the switch that selects the rotational speed of the rotor.
Rotating the knob to the right of center will speed up the rotational speed. Rotating the knob to
the left of center will slow down the rotational speed.
The DEPTH/LEVEL knob is assigned to control separation (the spatial spread of the sound). If
you are listening in stereo, rotating this knob toward the right will increase the spatial spread of
the sound.
Rotational Spatial
speed of spread of
the rotor the sound
21