Roland RD-600 - Reverb and Chorus Parameter Details; Reverb HF Dump and Delay Feedback; Chorus Level, Rate, and Depth

St RRS TTI TP TIN A IT NSE RE DO NET PIR I OE I RE EP I BESTE SOLE TOE SETS TY AE a EE BNE TE EE ETE,
High frequency attenuation (Reverb HF Dump)
This specifies the frequency at which the high range will be cut. As the frequency is lowered,
more of the high frequency range will be cut, producing a more mellow reverberation.
If you do not wish to cut the high frequency range, set this to BYPASS.
ERewerk HF Cures Setting values: 200, 250, 315, 400, 500, 630, 800, 1000,
#1 GGRHS 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000,
~_ BYPASS (Hz)
Number of delay repeats (Delay Feedback)
This adjusts the number of delay repeats. Increasing this setting will increase the number of
times that the delay sound is repeated. This parameter is valid only when a Reverb Type of
Delay or Pan-Delay is selected.
Ebelay Feedback
* &
Range of values: 0-127
About the Chorus parameters
Chorus settings include the following parameters.
Chorus Level
Chorus Rate
Chorus Depth
ChorusPreDelay
ChorusFeedback
Chorus Output
Level (Chorus Level)
This sets the amount of the chorus sound. Increasing this value will increase the chorus sound.
EChorus Lewel +
es Range of values: 0-127
Modulation speed (Chorus Rate)
This sets the speed (frequency) at which the chorus sound will be modulated. Modulation will
become faster as this value is increased.
EChorus Fate
Range of values: 0-127
k 2
Modulation depth (Chorus Depth)
This sets the depth at which the chorus sound will be modulated. Modulation will become
deeper as this value is increased.
EChorus Dereth +
Range of values: 0-127
Fie
36