16
May 2006 SH-201/SH-201C
fig.00-0_120
Preparation of Test
1. Confirm the power of SH-201 and PC are both off.
2. Connect headphones to PHONES.
3. Connect the monitor speakers to OUTPUT L/R.
4. Connect the oscillator to INPUT L/R.
5. Connect the EV-5 to PEDAL.
6. Adjust MASTER VOLUME and EXT IN INPUT VOLUME to MIN.
If you want to execute 11. USB TEST (p. 22), you better boot up your PC
beforehand.
Entering Test Mode
Hold down the three switches ([AMP OVERDRIVE], [EFFECTS FX ON],
[EFFECTS EDIT]) at the right corner of the top panel, turn on the power.
After all LEDs are blinking, release the buttons.
Exiting Test Mode
Turn off the power of the SH-201.
Test Items
Execute the following fourteen items.
0. Test Mode Top Page
1. Mute TEST
2. Memory TEST
3. MIDI TEST
4. SOUND TEST (PHONES, OUTPUT, ANALOG INPUT)
5. A/D TEST1 (Bender & Modulation)
6. A/D TEST2 (Knob, Slider, Expression Pedal)
7. D-Beam Adjustment
8. D-Beam TEST
9. Switch/LED TEST
10. KEYBOARD TEST (8-tone check/2-tone check/Touch Sense check)
11. USB TEST
12. Noise TEST
13. Factory Reset
Skipping Test Items
[TAP] + [OCT DOWN] . . . . . . . Moves to the previous test item by force.
[TAP] + [OCT UP] . . . . . . . . . . . Moves to the next test item by force.
Roland
Oscillator Oscilloscope
for 3. MIDI TEST
for 11. USB TEST
To Next Page
Loading...
