Roland SH-201 - Smooth Pitch Connection (Portamento)

19
May 2006 SH-201/SH-201C
Modulation
When the PORTAMENTO LED blinks, move Modulation all the way away
from yourself.
When the maximum value is detected correctly, click sound rings and the
PORTAMENTO LED lights.
fig.05-3_300
When the SOLO/POLY LED blinks, return Modulation to its original position.
When the minimum value is detected correctly, click sound rings and the
SOLO/POLY LED lights.
If there is no problem on both Bender and Modulation tests, the test program
advances the next items.
6. A/D TEST2 (Knob, Slider, Expression
Pedal)
Executes the Knob, Slider and Expression Pedal tests.
Each LED corresponding to Knob, Slider and Expression Pedal light. (Refer to
the following table.)
Knob
Turn the knob all the way to the left; a click will sound when the correct
minimum value is produced.
Turn the knob all the way to the right; a click will sound when the correct
maximum value is produced.
A sweep sound will be heard between Min and Max.
Turn the knob to the center; when the correct center value is produced, a click
will sound and the corresponding LED will go dark.
Slider (without a center click)
Pull the slider all the way down; a click will sound when the correct minimum
value is produced
Push the slider all the way up; a click will sound when the correct maximum
value is produced.
A sweep sound will be heard between Min and Max.
Pull the slider all the way down; when the correct minimum value is
produced, a click will sound and the corresponding LED will go dark.
Slider (with a center click)
Pull the slider all the way down; a click will sound when the correct minimum
value is produced.
Push the slider all the way up; a click will sound when the correct maximum
value is produced.
A sweep sound will be heard between Min and Max.
Set the slider to the click (detent); when the correct center value is produced, a
click will sound and the corresponding LED will go dark.
Expression Pedal
Move the Expression Pedal (EV-5) between its minimum and maximum levels.
When the correct minimum value and maximum value are produced at the
lower and upper limits, a click will sound and the corresponding LED will go
dark.
All tests are completed, the test program advances to the next item
automatically.
Knob LED
OSC PITCH OSC 1
OSC DETUNE OSC 2
OSC PW/FEEDBACK OSC WIDE
MIX/MOD BALANCE MIX/MOD TYPE MIX
FILTER CUTOFF FILTER TYPE LPF
FILTER RESONANCE FILTER TYPE HPF
FILTER KEYFOLLOW FILTER TYPE BPF
AMP LEVEL AMP OVERDRIVE
EFFECTS TIME EFFECTS FX ON
EFFECTS DEPTH EFFECTS EDIT DELAY
AUDIO FILTER CUTOFF AUDIO FILTER SLOPE -12dB
AUDIO FILTER RESONANCE AUDIO FILTER SLOPE -24dB
LFO RATE LFO RATE
LFO DESTINATION 1 DEPTH LFO DESTINATION 1 PITCH 1
LFO DESTINATION 2 DEPTH LFO DESTINATION 2 PITCH 2
Slider LED
PITCH ENV A GROUP PRESET
PITCH ENV D GROUP USER
PITCH ENV DEPTH BANK A
FILTER ENV A NUMBER 1
FILTER ENV D NUMBER 2
FILTER ENV S NUMBER 3
FILTER ENV R NUMBER 4
FILTER ENV DEPTH NUMBER 5
AMP ENV A NUMBER 7
AMP ENV D NUMBER 8
AMP ENV S WRITE
AMP ENV R CANCEL
Expression Pedal LED
EXPRESSION PEDAL D BEAM EXPRESS