20
May 2006 SH-201/SH-201C
7. D-Beam Adjustment
Executes the adjustment of the D BEAM controller.
When the D BEAM PITCH LED blinks, place your hand at a distance of
approximately 5 cm and press [PLAY/STOP].
When the adjustment is completed, the D BEAM PITCH LED lights.
fig.07-1_300
* If the result is NG, you won't proceed to the HIGH setting.
When the D BEAM EXPRESS LED blinks, place your hand at a distance of
approximately 40 cm and press [PLAY/STOP].
When the adjustment is completed, the D BEAM EXPRESS LED lights.
fig.07-2_300
If D BEAM PITCH and D BEAM EXPRESS are both OK, the test program
advances to the next item automatically.
* If the result is NG, you won't automatically proceed to the next item.
8. D-Beam TEST
Tests the D BEAM controller.
The D BEAM FILTER/ASSGIN LED lights.
fig.08-1_300
Place your hand over the D BEAM, and verify that the value increases or
decreases according to the movement of your hand.
The current A/D value is shown by the WAVE selection LEDs. (All will be
dark for the minimum value, and all will be lit for the maximum value.)
Press [PLAY/STOP] to advance to the next item.
9. Switch/LED TEST
This tests the operation of each switch and LED.
When the AUDIO FILTER BPF LED lights, press the corresponding TEMPO
UP switch (see the table on the next page). The AUDIO FILTER BPF LED will
go dark.
Next, when the AUDIO FILTER NOTCH LED lights, press the corresponding
TEMPO DOWN switch. The AUDIO FILTER NOTCH LED will go dark.
Subsequently, the LEDs will light successively; press the corresponding switch
in the order indicated.
When all switches and LEDs have been tested, you will automatically proceed
to the next item.
In cases where there is both a red LED and a green LED, the order will be Red
(lit) -> Green (bright) -> Green (dim) -> unlit.
fig.09-3_500
fig.09-4_500
fig.09-5_500
A click will sound when you press a switch, but if multiple switches are
pressed, there will be no click sound nor will the LED go dark.
To Next Page
Loading...
