* CC stands for Control Change
* ānā within hexadecimal notations refers to the channel number.
Operation Action taken on SK-50 MIDI data transmitted as result
of action taken on SK-50
[Overall Settings]
Master level MASTER + 2 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.24)
Master Tune MASTER + 1 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.24)
Pedal assign MASTER + 3 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.25)
Bender velocity sens. MASTER + 4 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.25)
Modulation velocity sens. MASTER + 5 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.25)
Chorus master level MASTER + 6 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.25)
Chorus type CHORUS + BANK UP or DOWN -> None
CHORUS + NUMBER (SOLO Volume P.16)
Reverb master level MASTER + 7 ->MASTER +BANK UP/DOWN None
(SOLO Volume P.25)
Reverb type REVERB + BANK UP or DOWN -> None
REVERB + NUMBER(SOLO Volume P.18)
Fat ON/OFF FAT (SOLO Volume P.15) None
(When ON, notes an octave lower are added)
Pitch Bend/Modulation PITCH BEND None
ON/OFF (SOLO Volume P.19)
Key transpose ON/OFF KEY TRANSPOSE None
(SOLO Volume P.21) (When ON, key numbers shift by specified valu
Transposition amount KEY TRANSPOSE + BANK UP/DOWN None
(SOLO Volume P.21)
Local ON/OFF MIDI + 1 -> MIDI + BANK UP/DOWN None
(ENSEMBLE Volume P.23)
Program Change reception MIDI + 2 -> MIDI + BANK UP/DOWN None
ON/OFF (ENSEMBLE Volume P.24)
Program Change transmission MIDI + 3 -> MIDI + BANK UP/DOWN None
ON/OFF (ENSEMBLE Volume P.24)
Device ID MIDI + 4 -> MIDI + BANK UP/DOWN None
(ENSEMBLE Volume P.24)
[Procedures]
Initialize MASTER + 8 -> MASTER + 8 None
(SOLO Volume P.26)
Start sequencer MIDI + 5 (ENSEMBLE Volume P.25) System Realtime (FAH)
Stop sequencer MIDI + 6 (ENSEMBLE Volume P.25) System Realtime (FCH)
Transmit GM Setup Data MIDI + 7 -> MIDI + 7 (ENSEMBLE Volume P.26) See ENSEMBLE Volume p. 26
Transmit GS Setup Data MIDI + 8 -> MIDI + 8 (ENSEMBLE Volume P.26) See ENSEMBLE Volume p. 26
To Next Page
Loading...
