Connecting with an Apple Macintosh
Place the COMPUTER mode selection switch on the rear of the SK-50 at the RS422 position
(baud rate of 31.25 Kbps). Connect the COMPUTER cable (optionally available RSC-15APL)
between the modem or printer port on the rear of the Macintosh and the COMPUTER
connector on the SK-50.
* Make sure that the Interface Type (clock speed of the MIDI interface) is set to 1 MHz. The
window shown below (Settings) is accessed from the Apple MIDI Driver, and is where you
need to make the MIDI interface settings.
To Next Page
Loading...
