164
Using
only
the VS-700C Console
(Standalone Mode)
You can connect the VS-700C console via its USB connector directly to your computer and use it as a control surface.
About the Driver
If you are connecting the VS-700C console via its USB connector directly to your computer, you’ll need to install the
dedicated VS-700C driver. The VS-700C driver and a Readme file explaining how to install it are located in the
“Drivers/VS700C”
folder of the
“SONAR V-STUDIO 700 CD-ROM
.
”
For details on installing the driver, refer to the Readme file.
Settings on the VS-700C
Set the SETTING DIP switches located on the rear panel of the VS-700C console as shown below, and then turn the
VS-700C off, then on again.
fig.dsw1.eps
Limitations
• With the above setting, you won’t be able to connect the VS-700R I/O unit to the VS-700C.
• The VS-700C console’s audio functionality (AUX IN, PHONES 1/2) will not work.
Normal setting Stand-alone mode
VS-700_r_e.book 164 ページ ２００８年１１月２０日 木曜日 午後２時２８分
To Next Page
Loading...
