Roland Sonar V-Studio VS-700 - Mapping Assignable ACCESS PANEL Buttons

66
ACCESS PANEL Section (Assignable Buttons)
To map assignable ACCESS PANEL buttons:
1.
Do one of the following to open the VS-700 property page:
• On SONAR’s “ Tools ” menu, click “ VS-700 .”
• On the “ Controllers/Surfaces ” toolbar ( Views > Toolbars > Controllers/Surfaces ), make sure “ VS-700 ” is selected in
the dropdown menu and then click the “ Properties ” button
.
• On the VS-700C Console, press [COMMAND]+[I/O CONTROL] buttons.
The VS-700 property page appears.
2.
Click the “SURFACE” tab.
The 16 assignable buttons are displayed along with their current assignments.
fig.31-2.eps
A. ACCESS PANEL button assignments
3.
On the “VS-700” property page, click the ACCESS PANEL button that you would like to assign.
The “ Button Properties ” dialog appears.
4.
Do one of the following:
• Click “ Host Command ” if you want the button to trigger a SONAR command.
• Click “ Keystroke ” if you want the button to trigger a raw keystroke.
When keystrokes are used, the VS-700C Console substitutes friendly names for the keystrokes where possible. For
example, the F1 key is displayed as “Help”.
• Click “Transport State” if you want the button to trigger a transport function.
fig.32.eps
A. Assign to a SONAR command
B. Assign to a keystroke
C. Assign to a transport function
Mapping Assignable ACCESS PANEL Buttons
A
A
B
C
VS-700_r_e.book 66 ページ ２００８年１１月２０日 木曜日 午後２時２８分