EasyManua.ls Logo

Roland Sonar V-Studio VS-700 - Controlling Plug-Ins from the VS-700 C Console

Roland Sonar V-Studio VS-700
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
74
Controlling Plug-ins from the VS-700C Console
You can display, insert, delete and bypass track and bus plug-ins, directly from the VS-700C Console. The VS-700C
Console must be put in Plug-in mode in order to edit plug-ins.
To Enable Plug-in Mode
Hold down the [CTRL] modifier button and press a channel strip’s [SEL] button.
When Plug-in mode is enabled, the names of existing plug-ins on the selected channel strip are displayed across the
LCDs. If the selected channel strip doesn’t contain any plug-ins (FX bin is empty), “No Plugins” appears on the LCD
display.
Up to 8 plug-ins are displayed on the upper and lower rows of the LCDs as follows.
Each plug-in name is shown with up to 16 characters, which is the width of two channel strips. For each pair of plug-
ins (top and bottom row), the left channel strip corresponds to the top plug-in and the right channel strip
corresponds to the bottom plug-in.
To Insert a Plug-in
1.
Make sure Plug-in mode is enabled (refer to “To Enable Plug-in Mode” (p. 74)).
2.
Press the [ARM] button on the channel strip that corresponds to the position at which you want to
insert a new plug-in.
The [ARM] button flashes to indicate the insert position (plug-in 1–8).
3.
Turn the encoders to find the plug-in that you wish to insert.
The available plug-ins are presented on the LCD displays in a hierarchical fashion. An Item is either a plugin or a
submenu of more plug-ins. If the item is a submenu of more plug-ins, the item has a “>” character appended to the
name and the items in the submenu are shown on the next encoder to the right.
4.
Press the encoder button to insert a plug-in.
The selected plug-in is inserted in the position indicated by the flashing [ARM] button and the LCD displays revert to
showing the existing track info on the selected channel strip.
You can undo and redo any inserted plug-in. To undo, press the [UNDO] button. To redo, press [SHIFT]+[UNDO]
buttons.
LCD row
Channel strips
1-2
Channel strips
3-4
Channel strips
5-6
Channel strips
7-8
Top
Plug-in 1 Plug-in 3 Plug-in 5 Plug-in 7
Bottom Plug-in 2 Plug-in 4 Plug-in 6 Plug-in 8
VS-700_r_e.book 74 ページ 2008年11月20日 木曜日 午後2時28分

Table of Contents

Related product manuals