Roland Sonar V-Studio VS-700 - I;O Control

44
CHANNEL STRIP Section
When I/O CONTROL mode is enabled, you can use the channel strip rotary encoders to control the Mic Pre Gain,
Threshold, Attack and Release parameters on the VS-700R I/O.
Additional I/O parameters can be controlled from the VS-700 property page, plus the stereo digital input mode and
digital sync mode.
From the VS-700C console:
1.
Press the VS-700C’s [I/O CONTROL] button.
2.
Press the VS-700C’s [ASSIGN] button to assign
the desired I/O parameter to the channel strip
encoders.
The available parameters are as follows:
• Mic Pre Gain (p. 84)
• Threshold (p. 85)
• Attack (p. 85)
• Release (p. 85)
From the VS-700 property page:
1.
Make sure the “VS-700” plug-in has been enabled in SONAR (see “Running SONAR for the First
Time” in VS-700 Getting Started).
2.
Do one of the following to open the VS-700 property page:
• On SONAR’s “ Tools” menu, click “ VS-700 ”.
• On the “ Controllers/Surfaces ” toolbar ( Views > Toolbars > Controllers/Surfaces ),
make sure “ VS-700 ” is selected in the dropdown menu and then click the [Properties] button
.
• On the VS-700C console, push [COMMAND] + [I/O CONTROL].
The VS-700 property page appears.
3.
Click the “MIC PRE” tab.
4.
Adjust the desired parameters.
I/O Control
VS-700_r_e.book 44 ページ ２００８年１１月２０日 木曜日 午後２時２８分