EasyManua.ls Logo

Roland Sonar V-Studio VS-700 - Page 22

Roland Sonar V-Studio VS-700
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Panel Descriptions
E. DIGITAL 2 OUT Connector
This is an ADAT output connector. You can connect it to an ADAT device and output up to eight channels of audio.
DIGITAL 2 IN Connector
This is an ADAT input connector. It allows up to eight channels of input. The input signals are output directly to the
“VS-700 IN DIGITAL2 1-2” – “VS-700 IN DIGITAL2 7-8” ports of the audio driver.
“Connections to the Digital Connectors”
(p. 79)
F. DIGITAL 1 AES/EBU OUT Connector
This is an AES/EBU format two-channel (stereo) digital output. The same signal is also output to the COAXIAL OUT
connector. This will output the signal of the audio driver’s “VS-700 OUT DIGITAL1” port.
DIGITAL 1 AES/EBU IN Connector
This is an AES/EBU format two-channel (stereo) digital input. This is switched with the COAXIAL IN (S/PDIF)
connector. The input signal is output directly to the audio driver’s “VS-700 IN DIGITAL1” port.
“Connections to the Digital Connectors”
(p. 79)
DIGITAL 1 COAXIAL OUT Connector
This is an S/PDIF format two-channel (stereo) digital output. The same signal is also output to the AES/EBU connector.
This will output the signal of the audio driver’s “VS-700 OUT DIGITAL1” port.
DIGITAL 1 COAXIAL IN Connector
This is an S/PDIF format two-channel (stereo) digital input. This is switched with the AES/EBU connector. The input
signal is output directly to the audio driver’s “VS-700 IN DIGITAL1” port.
“Connections to the Digital Connectors”
(p. 79)
G. WORDCLOCK IN Connector
This is a WORDCLOCK input connector.
For details on checking and selecting the clock source, refer to
“Audio Clock Source”
(p. 82).
WORDCLOCK OUT Connector
This is a WORDCLOCK output connector. It outputs a clock at all times.
H. OUTPUT 1–10 Jacks
These are ten channels of audio output connectors. They allow a broad range of connections, such as for multi-
output in a surround system, or as sends for outboard effects. These are balanced outputs. They output the signals of
the audio driver’s “1-2 (VS-700)” – “VS-700 OUT 9-10” ports.
VS-700_r_e.book 22 ページ 2008年11月20日 木曜日 午後2時28分

Table of Contents

Related product manuals