76
Controlling Plug-ins from the VS-700C Console
To Control Plug-in Parameters
1.
In the CHANNEL STRIP CONTROL section, press the [ACT] button to enable ACT mode.
2.
As described below, place the focus on the plug-in that you want to control.
3.
Use the rotary encoders and buttons in the CHANNEL STRIP CONTROL section to control the
desired parameter(s).
You can also use the T-bar to control a single ACT parameter. For more information about using the T-bar, refer
to
“T-Bar Section”
(p. 69).
To switch ACT context to the first FX in the selected
channel strip’s FX bin
Hold down the [SHIFT] modifier button and press the
[ACT] button in the CHANNEL STRIP CONTROL section.
To switch ACT context to the first synth in the Synth
Rack
Hold down the [CTRL] modifier button and press the [ACT]
button in the CHANNEL STRIP CONTROL section.
To navigate to other ACT contexts
Hold down the [COMMAND] modifier button and press
the [PAGE LEFT] or [PAGE RIGHT] button.
VS-700_r_e.book 76 ページ ２００８年１１月２０日 木曜日 午後２時２８分
To Next Page
Loading...
