Roland V-Accordion FR-18 diatonic - Personalizing Your FR-18 Diatonic

Before you start playing
20
r
V-Accordion FR-18 diatonic
Personalizing your FR-18 diatonic
The artwork you see behind the treble registers (above
the Roland logo) can be replaced either with one of the
sheets supplied with the FR-18 diatonic or with a
graphic you create yourself. To do so, proceed as fol-
lows:
1. Use the supplied hexagonal wrench to
loosen the two screws holding the “traforo”
cover:
There is one screw on either side.
Be careful not to turn the screws too far—they
should remain in the traforo cover.
2. After loosening both screws, you can open
the traforo cover:
NOTE
Be careful not to scratch the housing of your FR-18
diatonic.
3. Remove the sheet from underneath the
traforo cover and insert another one.
While creating your own sheet, pay attention to the
following:
• You can use your color printer and a graphic pro-
gram to create your own artwork.
• Be sure to use paper or rather thin media—card-
board is usually too thick.
•For a professional look, be sure to prepare a sheet
with the following dimensions: 297mm (L) x 89mm
(H).
4. Secure the traforo cover by tightening the
two screws using the supplied hexagonal
wrench.
FR-18d GB.book Page 20 Wednesday, December 15, 2010 1:54 PM