Roland V-Accordion FR-18 diatonic - Editing User Programs

Saving your settings (User Programs)
36
r
V-Accordion FR-18 diatonic
Editing a User Program
You can also change the settings of an existing User
Program.
1. Press the [USER PROGRAM/DEC] button to
enter User Program mode.
The button lights.
2. Press the treble register ([1]~[4]) that is
assigned to the User Program whose set-
tings you want to use.
The register you press lights red.
3. Press and hold the [USER PROGRAM/DEC]
button again (it flashes).
4. Change the desired settings (accordion,
orchestra registers, etc.).
5. Press the [USER PROGRAM/DEC] button (it
flashes rapidly).
One treble register lights to indicate the User Pro-
gram that is currently in use.
6. Press the treble register ([1]~[4]) that is
assigned to the User Program memory
where you want to save your settings.
The register you press lights and the [USER PRO-
GRAM/DEC] button lights steadily.
NOTE
See also “Saving a User Program Set to a USB memory
(optional)” on p. 37 and “Saving your current settings” on
p. 35.
FR-18d GB.book Page 36 Wednesday, December 15, 2010 1:54 PM