Roland V-Piano - Playing; Selecting and Playing Sounds

34
Playing
This section explains how to play the V-Piano.
The V-Piano contains 24 different “tones” (preset tones). Here’s how to select and play these tones.
The sound will be interrupted when you switch tones, but this does not indicate a malfunction.
1.
Access the tone screen.
The tone screen will appear when you switch on the V-Piano’s power.
If any screen other than the tone screen is shown, press the [EXIT] button.
2. Press one of the [TONE 1]–[TONE 4] buttons.
With the factory settings, the following preset tones are assigned to the buttons.
[TONE 1] button: No. 001 Vintage Piano 1
[TONE 2] button: No. 008 Vintage Piano 2
[TONE 3] button: No. 015 All Silver 1
[TONE 4] button: No. 020 All Silver 2
fig.play-1.eps
3.
Try selecting other preset tones.
Make sure that the tone number is highlighted, and turn the [VALUE] dial.
This allows you to select preset tone numbers 001–024.
fig.play-2.eps
If the tone number is not highlighted, press the [EXIT] button.
Selecting and playing a sound
V-Piano_e.book 34 ページ ２００９年１月２８日 水曜日 午前９時１０分