Roland V-Piano - System and Tone Parameter Settings

77
Detailed settings for various functions (Utility screen)
With the Utility screen “1. System” shown, press the [WRITE] button; the parameters will be saved to system memory.
You cannot save just an individual parameter by itself. When you save the System parameters, all the parameters you modified
will be saved in a single operation.
1.
From the Tone screen, press the [FUNCTION] button to turn Function on.
The [FUNCTION] button will light.
2.
Press the [F4 (UTILITY)] button.
3.
Use the [F3 ( ▲ )] or [F4 ( ▼ )] buttons to select “1. System.”
fig.Util02.eps
4.
Press the [ENTER] button or the [F1 (ENTER)] button to access the system setting screen.
5.
Press the [WRITE] button.
6.
A confirmation message will appear. To save the system parameter, press the [F4 (OK)] button.
All of the System parameters you edited will be saved to System memory.
If you decide to cancel without saving, press the [F1 (CANCEL)] button.
Saving the System parameters
V-Piano_e.book 77 ページ ２００９年１月２８日 水曜日 午前９時１０分