88
Detailed settings for various functions (Utility screen)
3.
Assign a name to the setup file. Press the [F2 (RENAME)] button.
fig.UtilFileSave03.eps
• Use the [VALUE] dial to change the character.
• Press the [F1 (INSERT)] button to insert a space.
• Press the [F2 (DELETE)] button to delete the character at the cursor location.
• Press the [F3] button to move the cursor one character to the left.
• Press the [F4] button to move the cursor one character to the right.
When you’ve specified the name, press the [ENTER] button or the [EXIT] button to return to the previous screen.
4.
When you’ve finished entering the file name, press the [F4 (EXECUTE)] button to start saving the file.
fig.UtilFileSave04.eps
The screen will indicate “Executing...” while the file is being saved. Never turn off the power while this screen is shown.
fig.UtilFileSave05.eps
If a file of the same name already exists, the confirmation message “File Exists Overwrite OK?” appears. If you want to
overwrite the existing setup file, press the [F4 (OK)] button. If you want to re-save the file with a different name, press the [F1
(CANCEL)] button.
5.
When the file has been saved, press the [EXIT] button to return to the previous screen.
V-Piano_e.book 88 ページ ２００９年１月２８日 水曜日 午前９時１０分
To Next Page
Loading...
