122
Chapter 5 What to Do If
5-6 If a Message Appears
These are the main messages that appear on the machine's
display to prompt correct operation. They do not indi-
cate any error. Follow the prompts and take action ac-
cordingly.
[1n 2n 3n 4n ]
Only a small amount of ink remains. Replace the cartridge
indicated by the flashing number with a new cartridge.
[PRESS THE POWER KEY TO CLEAN]
If you're using ECO-SOL MAX ink, this appears when the
machine has been unused for about one month.
Switch on the sub power once a month.
☞ P. 65, "When Not in Use for a Prolonged Period"
[CLOSE THE COVER (FRONT COVER, SIDE
COVER or MAINTENANCE COVER]
Close the front cover, side cover, or maintenance cover. For
safety, the carriage does not operate while a cover is open.
[SHEET NOT LOADED SETUP SHEET]
Load media. This message appears when an attempt to per-
form a printing test was made while no media was loaded.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid
collects in the drain bottle. To clear the message, press
. If this screen appears, go to the [DRAIN BOTTLE]
menu and discard the discharged fluid in the bottle.
☞ P. 50, "Disposing of Discharged Ink"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain
bottle, then press
.
[NOW HEATING...]
Wait until the media heating system reachs the preset tem-
perature. Printing starts when
lights up.
You can stop printing by holding down
for one sec-
ond or longer while this is displayed. Pressing
makes
printing start immediately, without waiting to reach the pre-
set temperature.
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit. After
verifying, press
.
☞ P. 54, "Cleaning the Heads Using the Cleaning Kit"
[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press .
☞ P. 58, "Replacing the Wipers"
To Next Page
Loading...
Need help?
General