69
Chapter 4 Feature Reference
4-2 Setting the Location for Starting Output
Setting the Output-start Location
Procedure
➊
Use to move the
cutting carriage.
Align the center of the blade with the new output-start
location.
➋
Press .
➌
Press to save.
Description
You can set the output-start location at any location you prefer. Note, however, that this setting must be made for each
individual page. When the printing of one page finishes, the output-start location returns to its default value. When the
start location has been set,
lights up and screen displays the character “B” together with the output-possible
width at the location.
This feature is also available when you're printing or cutting various test patterns, and can help you use media with
less waste. Note, however, that the left and right positions are not restored to their defaults for test patterns.
If you’re using the separately available media take-up unit, never use
. Doing so may pull the media with
undue force, resulting in an error or malfunction.
Printing area
FUNCTION
BASE POINT
W1100mm
B
This indicates that the
output-start location has
been set.
Feed-direction
start location
Scan-direction
start location
Output-start
location
Feed-direction
Scan-direction
To Next Page
Loading...
Need help?
General