Roland VS-2480 - Page 15

15
Objects shown in the VGA display
INPUT MIXER
fig.mixer-eq
1. DYNAMICS switch
2. EQ switch
3. AUX SEND Level
4. MUTE switch
SOLO switch
AUTOMIX STATUS indicator/button
5. PAN knob
6. INPUT MIXER CHANNEL FADER
7. LINK switch
MASTER BLOCK
fig.mixer-eq
1. DIR PATH SEND Point switching
2. DIR PATH AUTOMIX STATUS
indicator/button
3. DIR PATH Level
4. AUX BUS SEND Point switching
5. AUX BUS AUTOMIX STATUS
indicator/button
6. AUX BUS Balance knob
7. AUX MASTER Level FADER
8. AUX BUS LINK switch
9. MONITOR PAN knob
10. MONITOR Level knob (display only)
It is not possible to change the monitor level in the screen. Use
the monitor level knob on the VS-2480 to adjust this.
11. DIR PATH SEND knob
12. MASTER FADER
13. DITHER bit (Off/24/23/.../8) selector
The pre/post setting will change in units of the AUX bus.
1
2
3
4
5
6
7
1
2
4
3
5
6
7
11
12
13
10
9
8