Roland XP-10 - Page 18

Chapter 2. Playing the XP-10
Ee a a I 2 i a I a a I
Selecting a Drum Set
With the factory settings, a Drum Set is assigned to
Part 10, so use PART[ <@ ]/[ B> ] to select Part 10 and
you can play percussion sounds from the keyboard.
* To play the percussion sounds which are assigned
to keys outside of the range of the keyboard, use the
Transpose function to shift the range of the key-
board (p.27).
If you want to select a different Drum Set for Part 10,
skip steps 1-6 in the following procedure.
If you want to play percussion instruments from
another Part, use the following procedure to make
settings.
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Part,” and
press [ENTER].
3. Press [9] several times to select “Tone Type.”
* If you hold down [ENTER] and press [9], you will
return to the previous item.
4. Use PART| <@ ]/[ > ] to select the Part to which
you want to assign a Drum Set.
* You will be able to select only two Parts (Upper Part
and Lower Part) if the Keyboard Mode (p.19) is set
to Dual, X-dual, or Split.
5. Use VALUE[-]/[+] to select either “DRUM1” or
“DRUM2.”
* To change the settings of other Parts, repeat steps
4-5,
Part Number
PART 1 CONTROL
Tone Type: DRUM1
DRUM1 is selected
6. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
7. Press [USER/PRESET] to choose either “Preset”
(Preset Drum Sets) or “User” (User Drum Sets).
8. Use the numeric keys ([1]-[0]) to specify the Drum
Set number (Preset 1-16, or User 1-20). If you make a
mistake, press [CANCEL] and enter the number once
again.
18
* You may also select Drum Sets using VALUE[-]/[+]
instead of the numeric keys. In this case, skip step 9.
9. Press [ENTER] to finalize the selection.
Drum Set Name
P 1>STANDARD
Dl Preset: O01
DRUM1 is selected
Drum Set Number
To change back from a Drum Set to a normal sound
(Tone), follow steps 1-6, but select “TONE” in step 5.
Notes when selecting a Drum Set
Whether each Part will play a Tone or a Drum Set is
determined by the Tone Type selection
TONE/DRUM1/DRUM2) in step 5 of “Selecting a
Drum Set.”
Up to 2 Drum Sets can be assigned to the Parts. The
same Drum Set will be selected for each Part whose
Tone Type is set to DRUMI. The same is true for a
setting of DRUM2.
~~
Example:
DRUM1 has been specified for Parts 1 and 2, and the
STANDARD Drum Set is selected. DRUM2 has been
specified for Part 3, and the POWER Drum Set is
selected.
In this situation if you change Part 1 from STAN-
DARD to ELECTRONIC, Part 2 will automatically be
set to ELECTRONIC.
Part 1
Tone Type: DRUM1 | STANDARD
Part 2 ELECTORONIC
Tone Type: DRUM1 | STANDARD
Part 3 ELECTORONIC
Tone Type: DRUM2} POWER
Part 4
Tone Type: Tone Piano1
Part 16 °
Tone Type: Tone