Roland XP-10 - Setting the Depth of the Modulation Lever Effect; Using a Pedalto Modify the Sound 2; What Canbe:controlled By. Apedal? S; Setting the Function of the Pedal

Chapter 3. Convenient performance functions
SS
a
IE
I
RE
IEE
I
IE
TEI
2S
IS
EI
TT
I
RET
Setting the depth of the Modulation Lever
effect
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Common”
and press [ENTER].
3. Press [9] several times to select “MOD Depth.”
* If you hold down [ENTER] while you press [9], you
will return to the previous item.
4. Use VALUE[-]/[+] to set the value (-64-+63).
Higher values will produce a deeper effect.
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
Using a pedal to modify the sound
Wheat can be controlled by a pedal?
A pedal can control one of the following nine func-
tions.
Functions assignable to the pedal
Since there is only one pedal jack, you need to connect
the type of pedal that is appropriate for the function
you wish to control.
To control the HOLD function, connect a pedal switch
(sold separately: DP-2/6, FS-5U, etc.)
To control a function other than HOLD, connect an
expression pedal (sold separately: EV-5, etc.)
HOLD
sustain the sound
EXPRESSION
adjust the volume
ENV TIME
modify the Attack Time (p.34) and the Release Time
(p.34)
PORTA TIME
modify the Portamento Time (p.26)
CUTOFF
modify the brightness of the sound
RESONANCE
modify the tonal character of the sound
RESO+CUTOFF
modify both CUTOFF and RESONANCE
RESO-CUTOFF
this produces an effect similar to a wah-pedal
R/RESO-CTOF
this produces a random wah effect. The sound will
abruptly disappear and reappear.
Setting the function of the pedal
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Common”
and press [ENTER].
3. Press [9] several times to select “PEDAL Asgn.”
* If you hold down [ENTER] while you press [9], you
will return to the previous item.
4. Use VALUE[-]/[+] to select the function that the
pedal will control.
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
* For some sounds the effect may not be very notice-
able, depending on the selected function of the
pedal (except for HOLD and EXPRESSION) and the
value of the following PEDAL Depth parameter.
Setting the depth of the pedal effect
1. Press [EDIT].
The indicator will light.
2. Use VALUE[-]/[+] to select “Perform Common”
and press [ENTER].
3. Press [9] several times to select “PEDAL Depth.”
* If you hold down [ENTER] while you press [9], you
will return to the previous item.
4. Use VALUE[-]/[+] to set the value (-64-+63),
Higher values will produce a deeper effect.
* If the pedal function is HOLD or EXPRESSION, the
Pedal Depth parameter is not available.
5. Press [EDIT].
The indicator will go off, and the previous display
will reappear.
29